Filter
Top Products
-24-
Model G0758 (Mfd. Since 2/14)
Table Travel
The table travels in two directions and is con-
trolled by handwheels, as illustrated in Figure 23:
• X-axis (longitudinal)
• Y-axis (cross)
X-Axis or Longitudinal Travel
(Left & Right)
Y-Axis or
Cross Travel
(In & Out)
Figure 23. Possible directions of table travel.
Graduated Dials
The handwheels have graduated dials that are
used to determine table movement in 0.002"
increments, with one full revolution equalling
0.100".
Rotate graduated dial to a relative starting point
(see Figure 24).
Figure 24. Graduated dial location.
Graduated Dial
X-Axis Handwheel
Tool Needed Qty
Hex Wrench 5mm .............................................. 1
To use X-axis handwheel:
1. Loosen both X-axis table locks shown in
Figure 25.
Note: To readjust positioning of table locks,
pull out and rotate.
2. Position table stops along front of table to
restrict table travel.
3. Adjust X-axis graduated dial to zero, then use
handwheel to move table.
Y-Axis Handwheel
The saddle does not have limit stops. To move
the table along the Y-axis, loosen the Y-axis
table locks shown in Figure 25, then use the
handwheel in front of the table in the same man-
ner as the X-axis handwheel.
Figure 25. X- and Y-axis table travel locks.
X-Axis
Table Locks
Y-Axis
Table Locks
Table Stops