Filter
Top Products
-14-
G1006/G1007 Mill/Drill
Drill Chuck/Arbor
Your Mill/Drill has been pre-fitted with a drill
chuck arbor that has an R-8 shank and a Jacob’s
Taper. It is ready to accept the standard drill
chuck provided with this machine.
To install the drill chuck:
1. Clean the grease off the drill chuck. Pay
particular attention to the bore in the drill
chuck: it must be free from all grease, oil
and debris.
2. Clean any grease, oil or debris off the
Jacob’s Taper already installed in your
Mill/Drill.
3. Retract the drill chuck jaws fully by turning
the body of the drill chuck clockwise.
4. Press the drill chuck onto the Jacob’s
Taper. Tap lightly with a rubber mallet to
get a good fit. Note: While it may not seem
like there is anything keeping the drill chuck
in place, the Jacob’s Taper fitting provides
a strong bond and will hold the drill chuck
tightly.
5. This drill chuck installation is permanent.
Do not try to remove the drill chuck from
the Jacob’s Taper.
Your Mill/Drill comes equipped with a fly cutter
that fits on the 1" stub end of the R-8 arbor.
To install the fly cutter:
1. Clean all grease, oil and debris off the R-8
arbor.
2. Clean all grease, oil and debris off the fly
cutter.
3. Fit the fly cutter onto the stub end of the
arbor so the keys on the arbor and the key-
ways on the fly cutter come together.
4. Secure the fly cutter to the arbor with the
cap screw and washer provided. Tighten
with an 8mm Allen
®
wrench.
5. Install the arbor with fly cutter into the
Mill/Drill as described in the section titled
COLLET/ARBOR.
Fly Cutter/Arbor
All types of milling cutters and drill bits are
sharp. It is recommended that these not be
handled directly. Use paper towels to hold
sharp tooling to avoid cuts to your hands.
Be careful while handling them and store
them in a child safe location.