Filter
Top Products
-16-
G1006/G1007 Mill/Drill
The G1006/G1007 is capable of twelve different
speed settings. Different types of cuts and types
of materials require varying speeds. Consult out-
side sources for information about appropriate
speeds for different applications.
To change speeds:
1. Loosen the motor locking lever. It is located
on the right side of the machine, near the
back. Pull the motor inward to move the
rear pulley toward the spindle.
2. Loosen the two bolts that hold the center
pulley system in place, so the pulley will
float.
3. With the center and rear pulleys loose,
move the V-Belts to the position on the pul-
leys corresponding to the desired speed
(See chart below).
4. Push the motor back to tighten the rear V-
Belt and tighten the motor locking lever.
5. Tighten the bolts holding the center pulley
in place.
Speed Changes
The head height on this Mill/Drill can be adjusted
for various applications.
To adjust the head height:
1. Loosen the two head locking nuts located
on the right side of the head near the back.
Use the lug wrench provided.
2. Use the head crank to move the head up or
down according to your needs.
3. Tighten the two head locking nuts.
Head Height