Filter
Top Products
-18-
Once assembly is complete and adjustments are
done to your satisfaction, you are ready to test
run the machine.
Turn on the power supply at the main panel.
Press the START button. Make sure that your fin-
ger is poised on the STOP button, just in case
there’s a problem. The Mill/Drill should run
smoothly, with little or no vibration or rubbing
noises. Strange or unnatural noises should be
investigated and corrected before operating the
machine further.
Test Run
Notes
If you cannot easily locate the source of an
unusual noise or vibration, contact our Service
Department for help. (See Introduction)
DO NOT make adjustments while the
Mill/Drill is running. Ensure that the switch
is off, power is disconnected and moving
parts have stopped before making adjust-
ments.
Operating this equipment has the potential
to propel debris into the air which can
cause eye injury. Always wear safety glass-
es or goggles when operating equipment.
Everyday glasses or reading glasses only
have impact resistant lenses, they are not
safety glasses. Be certain the safety glass-
es you wear meet the appropriate stan-
dards of the American National Standards
Institute (ANSI).
G1006/G1007 Mill/Drill