Filter
Top Products
G1013 Combination Sander -17-
SECTION 6: Operations
Before you put your Combination Sander into
use, give it a quick inspection with the machine
switched off and disconnected from its power
source.
1. Are all fasteners tight?
2. Is the sanding belt properly tracked and ten-
sioned?
3. Rotate disc slowly by hand. Look and listen
for any scraping noises or anything that
impedes smooth movement. Make appropri-
ate adjustments before attempting to run the
machine.
4. If the sander appears to be free of problems
that might affect its operation, plug it in to its
power source and start the machine. Be sure
to keep a finger on the OFF button, just in
case of a problem with the machine. Run the
sander briefly to allow inspection of belt
tracking.
5. Turn off the machine, disconnect it from its
power source, and re-inspect for loose fas-
teners. If the tracking is not correct, refer to
the tracking adjustment guidelines in the
Adjustments section.
Never use the Model G1013 for applications
other than those for which it was made. DO
NOT overload the machine or use excess
force when sanding. Severe personal
injury, damage to the machine, or damage
to your workpiece could occur.
Test-Run
Keep loose clothing out
of the way of machinery
and keep hair pulled
back.
Wear safety glasses dur-
ing all operations on the
shaper. Failure to com-
ply may result in serious
personal injury.
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.
Always wear a dust mask
when operating the
sander. Using this
machine produces saw-
dust which may cause
allergic reactions or res-
piratory problems.