Filter
Top Products
- 4 -
V. PIECE INVENTORY
Take a quick inventory of the parts and put them aside for assembly later.
Since the majority of the Model G1126 is pre-assembled at the factory, there aren’t a lot of items to
inventory. You should have the following:
• Mill / Drill Unit
• Power Feed
• Fly Cutter
• Handwheels
• Adjustment Wrench
• Flycutter
• Drill Chuck Arbor
• Quill Feed Rods (3 pcs.)
•
1
/2" Drill Chuck and Key
22. NEVER LEAVE THE TOOL RUNNING UNATTENDED - TURN POWER OFF. Do not leave the
tool until it comes to a full stop.
23. DRUGS, ALCOHOL, MEDICATION. Do not operate the tool under the influence of drugs, alco-
hol, or any medication. Never operate machinery when overly fatigued.
IV. UNPACKING
The Model G1126 comes from the factory in a wooden crate. While it is still on its pallet, use a fork-
lift (if available) to move the machine to its permanent location. Once in place, carefully remove the
crate surrounding the Model G1126 with a hammer or crowbar. Lift the Model G1126 with a sling
wrapped around the milling head to lift the machine off the pallet and onto your bench. Make sure
you tighten all the locks that restrict moving parts to avoid sudden shifts which could unbalance the
machine.
REMEMBER: Always wear ANSI-approved safety glasses when uncrating equipment.
If you find the machine is damaged after you’ve signed for delivery and the truck and driver are
already gone, you will need to file a freight claim with the carrier. Save the containers and all pack-
ing materials for inspection by the carrier or their agent. Without the packing materials, filing a freight
claim can be difficult. If you need advice regarding this situation, please call us.
Caution: The mill / drill weighs a hefty 660 pounds in its packaging. DO NOT attempt to move this
machine without proper lifting equipment.