Grizzly G1276 Sander User Manual


 
-18- G1183/1276 Combination Sander
Operating this equipment has the potential
to propel debris into the air which can
cause eye injury. Always wear safety glass-
es or goggles when operating equipment.
Everyday glasses or reading glasses only
have impact resistant lenses, they are not
safety glasses. Be certain the safety glass-
es you wear meet the appropriate stan-
dards of the American National Standards
Institute (ANSI).
Surface Sanding
To remove a large amount of material quickly
from a large surface area, use the belt arm in its
horizontal position.
1. Turn the sander on and let it reach its full
working speed.
2. Place the workpiece flat on the belt. Be
sure to hold the work securely with both
hands. Place one hand at the end of the
workpiece to feed it against the rotation of
the belt. Place the other hand lightly on top
of the workpiece to ensure adequate stock
removal. See Figure 18.
Figure 18. Surface sanding.
Disc Sanding
1. Loosen table lock knob and tilt work table to
desired angle. Tighten lock knob.
2. Use miter gauge to guide work into position.
3. Ease workpiece into the half of the disc that
spins down toward the table. See Figure 17.
Figure 17. Disc sanding.