Filter
Top Products
-6- G8622 Tilting Spindle Sliding Table Shaper
We do not recommend the use of extension
cords on 220V equipment. It is much better to
arrange the placement of your equipment and
the installed wiring to eliminate the need for
extension cords. Should it be necessary to use
an extension make sure the cord is rated Hard
Service (grade S) or better. Refer to the chart in
Section 1: Safety to determine the minimum
gauge for the extension cord. The extension cord
must also contain a ground wire and plug pin.
Always repair or replace extension cords when
they become worn or damaged.
Extension Cords
A wiring diagram is provided at the back of this
manual should it be necessary to repair or revise
the wiring. Always utilize a qualified electrician
when doing any electrical work on this equip-
ment.
Wiring
We have covered some basic electrical
requirements for the safe operation of
your machine. These requirements are not
necessarily comprehensive. You must be
sure that your particular electrical configu-
ration complies with local and state codes.
Ensure compliance by checking with your
local municipality or a licensed electrician.