Filter
Top Products
-10- H2801 4" Jointer
SECTION 4: ASSEMBLY
Beginning Assembly
Most of your Model H2801 4" Jointer has been
assembled at the factory, but some parts must be
assembled or installed after delivery. We have
organized the assembly process into steps.
Please follow along in the order presented in this
section.
Trunnions
Figure 3. Trunnions mounted to fence.
Keep loose clothing out
of the way of machinery
and keep hair pulled
back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Do not connect this
machine to the power
source until all assembly
and adjustments have
been performed!
The plunger trunnion and the scale trunnion need
to be attached to the rear of the fence. To attach
the trunnions:
1. Attach the scale trunnion to the left end of
the fence with two M5-.8 x 10 countersunk
screws from the front of the fence.
2. Attach the plunger trunnion to the right end
of the fence with the other two M5-.8 x 10
countersunk screws from the front of the
fence.
3. Ensure that the trunnions are mounted tight
and the screw heads are below the surface
of the fence. Your assembly should look sim-
ilar to Figure 3.
Some metal parts may
have sharp edges on
them after they are
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.
Plunger Trunnion
Scale Trunnion