Filter
Top Products
H2801 4" Jointer -11-
Fence
To attach the fence to the jointer table:
1. Mount the fence assembly as shown in
Figure 4 with the four M5-.8 x 10 cap screws
and lock washers.
2. Verify that the fence is secure.
Figure 4. Attaching fence to jointer.
Mounting Jointer
The Model H2801 weighs approximately 22 lbs.
Make sure that the workbench on which you plan
to mount the jointer is sturdy enough to hold the
combined weight of the machine and the wood
stock being processed. The workbench should
have a level surface and be heavy enough, or
attached to the floor, so it will not move during
operation. To mount the jointer:
1. Pick a spot on the workbench that will allow
enough room to move the workpiece through
the entire cut. The operator (and possibly
bystanders) should have enough room to
stand out of the line of the cut in the event
that a kickback occurs.
2. Mount the jointer to the workbench with bolts
that are long enough to exceed the thickness
of your workbench and the jointer base.
Secure these bolts with a flat washers, a
lock washer and a hex nut. Because sizes
vary for each individual situation, the hard-
ware in this step is not included with the
Model H2801.
Figure 5. Jointer mounted to workbench.