Filter
Top Products
-12- H2801 4" Jointer
Figure 7. Measuring cutting depth.
Figure 6. Straightedge across outfeed table.
Cutting Depth
Cutting depth is controlled by moving the infeed
table up/down in relation to the cutterhead and
outfeed table. The infeed table can be controlled
by turning the adjustment knob beneath the
infeed table. To adjust the cutting depth:
1. Place a straightedge evenly on the surface
of the outfeed table so the straightedge
extends over the cutterhead and across the
infeed table as shown in Figure 6.
2. Measure the distance from the infeed table
to the bottom of the straightedge as shown in
Figure 7. This measurement will be the
depth of cut.
3. Adjust the infeed table to the desired depth
of cut. The maximum depth of cut for this
machine is
5
⁄64". However, we recommend
cutting at
1
⁄16" depths for increased safety.
SECTION 5: ADJUSTMENTS
Keep loose clothing out
of the way of machinery
and keep hair pulled
back.
Wear safety glasses dur-
ing the entire adjustment
process. Failure to com-
ply may result in serious
personal injury.
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.
Do not exceed a cutting depth of
5
⁄64". Failure
to follow this caution will seriously increase
the risk of kickback and possible injury!