Filter
Top Products
H3114 Router Table -9-
To check the flushness of the table:
1. Place a straightedge across both extension
tables and the main table. The straightedge
should sit flush on all three surfaces as
shown in Figure 6.
2. If either extension table is not flush with the
main table, loosen the mounting screws and
adjust the assembly until both extension
tables and the main table are flush with one
another.
3. Retighten the mounting screws.
4. Double check the the flushness of the work-
ing surface with the straightedge.
Figure 6. Using a straightedge to ensure the
working surfaces are flush.
Figure 4. Aligning a leg with the main table.
Figure 5. Securing a leg to the main table.
3. Align one of the legs with the mounting holes
on the inside edge of the main table as
shown in Figure 4.
4. Secure the leg and extension table to the
main table with the supplied #10-32 x
3
⁄4"
truss head phillips screws and the #10-32
keps nuts as shown in Figure 5.
5. Repeat Steps 3 & 4 for the remaining three
legs.