Filter
Top Products
H3114 Router Table -13-
Figure 16. Router table mounting holes.
Figure 17. Miter gauge components.
Figure 18. Assembled miter gauge.
To secure the router table to a workbench:
The bottom of each leg has two holes (
Figure 16
)
used for mounting the router table to the work-
bench. Secure the router table to the workbench
with wood screws and washers.
To assemble the miter gauge (Figure 17 & 18):
1. Attach the miter body to the miter bar with the
supplied M4 x 12 tap screw.
2. Place the M8 flat washer over the M8-1.0 x
12 knob bolt.
3. Slide the M8-1.0 x 12 knob bolt through the
miter body slot and thread it into the miter
bar.
Tap Screw
Miter Body
Knob Bolt
Miter Bar
Flat Washer