Filter
Top Products
H3118 Tile Saw -11-
Before starting the machine:
1. Read this manual and make sure you follow
all safety precautions before operating this
machine.
2. Make sure the blade guard is installed and is
covering the blade above the table surface.
3. Make sure the blade cover is installed and is
covering the blade below the table.
4. Make sure all tools or foreign objects have
been removed from the machine.
5. Review Section 3: Circuit Requirements
beginning on Page 6 and make sure all
wiring is correct.
Starting the machine:
1. Wear safety glasses at all times when
running the saw!
2. With dry hands, a dry plug, and dry feet, plug
the saw into the power source.
Start Up
Loose hair and clothing
could get caught in
machinery causing seri-
ous personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses at all
times.
Figure 4. Correct cord positioning.
“Drip Loop” Below The
Level Of The Outlet
Be sure the cord is positioned with a “drip
loop” below the level of the outlet as shown
in
Figure 4
. This prevents water from run-
ning down the cord and into the outlet.
Instead the water will drip to the floor at the
“drip loop” on the cord.
Operating, plugging, or unplugging any
electrical machine into a power source with
wet hands or feet could cause electrocution.
Dry off hands and power plug, and make
sure feet and ground are dry before plug-
ging or unplugging any electrical machine
into a power source.