Filter
Top Products
-14- H3118 Tile Saw
Figure 8. Diagonal cutting with the miter gauge.
45˚ Miter Cutting
Diagonal cuts can be made on rectangular tiles
using the supplied miter gauge. Figure 8 shows
a typical set up for cutting the corner off of a
square tile.
Figure 9. Tilting the table for bevel cutting.
Bevel Cutting
The saw table can be tilted up to 45˚ to accom-
modate bevel cutting. Loosen the knob on the
front of the saw to adjust the saw table as shown
in
Figure 9
. Use the scale on the front of the saw
to set the desired table tilt angle. Retighten the
knob to secure the table.
Scale