Filter
Top Products
-16- H3118 Tile Saw
Blade Changes
To change/install the blade:
1. Unplug the machine from the power
source!
2. Remove the water tray from underneath the
tile saw.
3. Remove the blade cover by removing the
screws on each side of the blade cover
(
Figure 10
).
Figure 10. Loosening one of the
blade cover screws.
4. Use a 19mm and an 8mm open-end wrench
to loosen and remove the arbor nut from the
motor spindle as shown in Figure 11.
5. Slide the outer flange (
Figure 11
) and the
saw blade off the end of the motor spindle.
6. Slide the new blade and the outer flange over
the end of the motor spindle. Note–Make
sure the directional arrow printed on the saw
blade is pointing in a counter-clockwise
direction when viewing the saw facing the
arbor nut.
7. Thread and tighten the arbor nut onto the
motor spindle to secure the saw blade.
8. Re-install the blade cover.
!
Figure 11. Removing the arbor nut.
!
Outer Flange
Blade
Rotation
Arbor Nut