Grizzly G5959 Saw User Manual


 
-18- G5959/G9957 12" Table Saw
Figure 18. Setscrew on each corner of insert.
Table Insert
The table insert provides access to the blade and
arbor when removed. When in place, the insert
provides support for materials being cut.
1. Disconnect the power cord from the outlet.
2. Ensure that all four setscrews are firmly in
contact with the table casting.
3. Using a 6mm hex wrench, raise or lower
each of the four setscrews (
Figure 18)
until
the insert is flush with the table top.
4. Now make sure the blade will not come into
contact with table insert. Position the blade at
90°, then raise and lower the blade through its
full range of motion. Also, rotate the blade
while doing this, making sure that the blade
never contacts any part of the table insert. Do
the same with the blade in the 45° position.
Wear leather gloves while rotating the blade
to prevent being cut.
5. Be sure to review the “Blade Alignment,”
instructions before operating the saw.
Disconnect power to the
machine when perform-
ing any maintenance,
assembly or adjust-
ments. Failure to do this
may result in serious
personal injury.
!