Filter
Top Products
G5959/G9957 12" Table Saw -5-
Push Sticks
The use of push sticks (shown in Figure A), par-
ticularly when cutting small or narrow workpieces,
provides a double benefit for saw operators. The
push stick provides added leverage, enabling the
operator to keep the workpiece firmly supported
against the fence and table. At the same time, the
push stick keeps the operator’s hand safely away
from the rotation of the saw blade. See the tem-
plate at the end of the manual for construction
details, or purchase one from the Grizzly catalog.
Zero Clearance Table Inserts
Ideal for use when ripping thin strips or making
bevel cuts, these prevent tearout and jammed
blades by supporting material close to the blade.
Use the standard table insert as a template when
creating additional inserts from wood or plywood.
Blade slot inserts can be custom cut for specific
blade angles by raising the running blade into an
uncut insert at the angle you desire. Be sure to
make an additional slot for the blade splitter. We
also carry a wide selection of table inserts (shown
in Figure 1) in the Grizzly catalog. Be sure to hold
the insert firmly in place with a piece of wood
when creating slots. Never hold the table insert
with your hand while cutting new slots.
Safety Accessories
Statistics prove that most common acci-
dents among table saw users can be
linked to kickback. Kickback is typically
defined as the high-speed expulsion of
stock from the table saw toward its opera-
tor. In addition to the danger of the opera-
tor or others in the area being struck by
the flying stock, it is often the case that
the operator’s hands are forced into the
blade during the kickback. The following
can help minimize kickbacks.
1. Use your blade guard and splitter.
2. Never for any reason place your hand
behind the blade. Should kickback
occur, your hand will be pulled into the
blade.
3. Inspect splitter for alignment between it
and your blade.
4. Never use the fence as a guide for cross-
cutting.
5. Never attempt freehand cuts.
6. Use a pushstick or featherboard to main-
tain control of your workpiece.
7. Feed cuts through to completion.
8. Stand to the side when ripping.
9. Ensure your fence and miter slot are par-
allel to the blade.
If you do not have a clear understanding of
kickback and how it occurs, do not operate
this table saw.
Figure A. Push Stick.