Filter
Top Products
-10-
Model T10726 (Mfg. Since 12/12)
SECTION 3: OPERATIONS
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
Damage to your eyes or hands could result
from using this brake without proper protec-
tive gear. Always wear safety glasses and
leather gloves when operating this brake.
Basic Bending
The Model T10726 bends mild steel up to 22
gauge at angles up to 90°.
To perform a basic bending operation:
1. Clean away any debris from the workpiece.
2. Use a pencil or scribe to mark the bending
location.
3. Lift the operating lever and center the
workpiece under the fingers and directly over
the mark you made in Step 2 (see Figure 6).
Figure 6. Workpiece positioned under fingers.
Keep your fingers and
hands away from the fin-
gers during operation to
avoid the risk of crushing
injuries.