Filter
Top Products
Model T10726 (Mfg. Since 12/12)
-15-
Review the troubleshooting and procedures in this section if a problem develops with your machine. If you
need replacement parts or additional help with a procedure, call our Technical Support at (570) 546-9663.
Note: Please gather the serial number and manufacture date of your machine before calling.
SECTION 6: SERVICE
Troubleshooting
Symptom Possible Cause Possible Solution
Heavy resistance
during bends.
1. Machine capacities are exceeded.
2. Fingers not aligned with finger receiver
groove.
1. Use sheet metal that does not exceed 22 gauge
mild steel.
2. Make sure fingers are aligned with finger receiver
groove as fingers are lowered for bend.
Bend radius is not
consistent across
workpiece.
1. Machine capacities are exceeded.
2. Bottom of fingers not aligned with each
other.
1. Use sheet metal that does not exceed 22 gauge
mild steel.
2. Make sure fingers are firmly seated in finger clamps
and the finger points are aligned with each other.
Point of fingers are
chipping or rolling.
1. Fingers not aligned with finger receiver
groove.
2. Machine capacities are exceeded.
1. Make sure fingers are aligned with finger receiver
groove as fingers are lowered for bend. Replace
fingers if damaged.
2. Use sheet metal that does not exceed 22 gauge
mild steel. Replace fingers if damaged.
Workpiece shows
scoring marks or
scratches after
bend.
1. Debris on fingers or finger receiver.
2. Fingers or finger receiver has scratches.
1. Clean fingers and finger receiver (Page 14).
2. Polish out scratches, and apply tape on the
workpiece at the bend locations for protection.