Filter
Top Products
-16-
Model T10726 (Mfg. Since 12/12)
Finger Alignment
To produce straight bends, the finger points (see
Figure 18) must all be aligned evenly.
When moving or re-installing the fingers, there is
play in the vertical positioning which can be used
to align the fingers.
Look along the length of the fingers from the side
to identify any finger point that is not aligned with
the rest.
Tool Needed Qty
Hex Wrench 6mm .............................................. 1
To align the finger points:
1. Loosen, but do not remove, the cap screws
that secures the finger.
Note: It may be necessary to also loosen
the cap screws on each side of the finger to
relieve the pressure from the finger clamp.
2. Apply upward pressure to the finger to firmly
seat it into the finger clamp.
3. Observe the alignment of the finger points
from the side again. If necessary, repeat this
procedure to bring all fingers into alignment.
Figure 18. Finger points and cap screws.
Finger Points
Finger
Clamp
Finger
Cap Screws