Filter
Top Products
Model T26416 Crown Stapler -9-
Test Run
Prior to using the stapler for regular opera-
tions, perform this test run procedure on
a scrap workpiece at least 1
1
⁄2" thick to
ensure it functions properly.
To test run stapler:
1. Insert staples into stapler, following
directions in Loading Staples section.
2. Firmly holding stapler with nose point-
ing away from you and others, connect
stapler to air supply.
3. Clamp the scrap workpiece to a work-
station.
4. Press the stapler against the scrap
workpiece and fully depress the safety
probe (see Figure 6).
5. Pull the trigger on the stapler.
6. Inspect scrap piece to ensure staple
was driven correctly.
7. As a one time test of the safety mecha-
nism, pull the stapler back from the
scrap piece until the safety probe is no
longer depressed. Angle the stapler so
the ricochet trajectory is away from you
and others, then pull the trigger.
— If the stapler did not fire then the
safety mechanism is working cor-
rectly.
— If the stapler did fire, the safety
mechanism is not working correctly.
Carefully disconnect the air supply
and contact tech support to resolve
the problem before using the stapler
any further.
Figure 6. Safety probe depressed.
Safety
Probe
Extended
Safety
Probe
Depressed