Filter
Top Products
Model T26416 Crown Stapler-12-
SECTION 6: MAINTENANCE
Disconnect the stapler from the air supply
before cleaning. Use a good solvent to
clean the nose assembly of the stapler.
Always be sure that the stapler is dry
before using it again.
Do not allow dust, chips, sand, etc. into the
air connectors or into the body of the sta-
pler; this may result in leaks and damage
to the stapler and the air couplings.
Never use gasoline or other flamma-
ble liquids to clean this tool. Vapors
in the tool may ignite, causing the
tool to explode. Ignoring this warning
may lead to serious personal injury
or even death!
Cleaning Lubricating
Place two to six drops of pneumatic tool oil
in the nailer air inlet (as shown in Figure
11) every 2 hours of continuous use. Wipe
off any excess oil near the nailer exhaust
to avoid dust build-up.
Figure 11. Lubricating stapler via air inlet.
Another option to manual oiling would be
to simply install a lubricator in your air
compressor line. If your air compressor
line already has a lubricator, then regular
lubrication of your nailer will not be neces-
sary. Just make sure there is always oil in
the lubricator.