Filter
Top Products
Model T26416 Crown Stapler-10-
ACCIDENTAL
START HAZARD!
Disconnect before
service or staple
replacement.
AIR PRESSURE
HAZARD!
Never exceed max
PSI rating for tool.
LUNG/EAR
INJURY HAZARD!
Wear protective
equipment when
using this tool.
SECTION 4: OPERATIONS
EYE INJURY HAZARD!
Wear safety glasses when using
this tool.
The purpose of this overview is to pro-
vide the novice tool operator with a basic
understanding of how the tool is used.
To perform a typical operation:
1. DISCONNECT STAPLER FROM AIR
SUPPLY!
2. Check to ensure there are enough
staples in the magazine and reconnect
to air supply.
3. Drive a staple into a scrap piece of the
same material, and inspect the depth of
the driven staple.
If the staple was not driven in the cor-
rect depth, use the depth adjustment
wheel to properly set the staple depth
(see Figure 7). Rotating the wheel
clockwise (from the backside) increas-
es the depth, while rotating counter-
clockwise decreases the depth.
Deflection due to material irregulari-
ties can cause puncture injuries to
improperly placed hands or body
parts. Always position hands and
body away from staple trajectory
and deflection paths.
4. Align workpieces to be stapled.
5. Place safety probe
1
⁄8" above the staple
insertion target, and push down the sta-
pler until it is butted up against and per-
pendicular with the bottom workpiece.
6. Before pulling the trigger, make sure
your free hand and other body parts
are out of staple trajectory or deflection
paths.
7. Pull the trigger.
Figure 7. Depth adjustment wheel.
Depth
Adjustment
Wheel