Filter
Top Products
To Install A Sanding Disc:
1. WARNING! Prior to performing any assembly procedures, make sure
the Power Switch (30) is in its “OFF” position and the Power Cord (29) of
the Sander is unplugged from its electrical outlet.
2. Check to make sure the Disc (11) is free of dirt, oil, and other debris.
(See Figure G.)
3. Remove the paper backing on the adhesive Sanding Disc (12), and stick the
Sanding Disc firmly and evenly on the Disc (11).
IMPORTANT: To avoid dam-
age to the machine, make sure there is a 1/16” gap between the Sanding Disc
and the Work Table (13). (See Figure G.)
SKU 05154 PAGE 12
DISC
(11)
SANDING
DISC
(12)
FIGURE G
To Adjust The Angle Of The Work Table:
1. WARNING! Prior to performing any assembly procedures, make sure
the Power Switch (30) is in its “OFF” position and the Power Cord (29) of
the Sander is unplugged from its electrical outlet.
2. The angle of the Work Table (13) may be adjusted from 0 to 45 degrees to allow
for bevel sanding. (See Figure H, next page.)
3. To adjust the angle, slightly loosen the Lock Screw (15). (See Figure H.)
4. Observe the gauge on the Angle Plate (14). Raise or lower the Work Table (13)
to set the Work Table to the desired angle. Then, retighten the Lock Screw (15)
to lock the Work Table in place. (See Figure H.)