Filter
Top Products
Drill Speed Table Note: Spindle Belt M24, Motor Belt M25
The table below shows the belt arrangements for given drill speeds (a full chart
is also located on the inside of the pulley cover).
After Operation
1. Remove all residue from the machine and thoroughly clean all surfaces.
2. Make sure all components are dry and machined surfaces lightly oiled.
3. Remove drill bits and store in a safe place.
4. Child-proof the machine and work area. Make sure to use padlocks, master switches and remove starter keys.
Grounding/Voltage Warning
Common household current is 110-120 volts. As long as your tool is rated from 110-120V there will be no complications using
this tool with household receptacles. Plug the press into a 110-120V properly grounded outlet protected by a 15-amp, dual
element time delay or circuit breaker.
NEVER try to plug a 110-120V tool into a 220-240V circuit (or vice-versa) or serious complications and possible injury to the
operator may occur. The plugs have different shapes to prevent this.
This piece of equipment has a three-prong plug. The third (round) prong is the ground to protect the operator from electric shock.
Cutting off the ground will result in a safety hazard and void the warranty.
#38144 REV 10/03 Page 10