Filter
Top Products
Page 12 For technical questions, please call 1-800-444-3353. SKU 66755
The Battery Packs
Two Battery Packs (1) are included •
with this tool kit. They can be used in
combination with the Work Light and
any of the other tools at the same time,
or you can have an extra fully charged
stand-by Battery Pack available for use
when needed.
Charge both Battery Packs before us-•
ing the tools.
Charge the Battery Pack (1) only with •
the 18V Charger (3) provided.
Charge indoors only. •
If the Battery Pack is hot from use in •
a tool, allow time for it to cool down
before Charging.
If the Battery Pack is hot after charging, •
allow time for it to cool down before us-
ing in a tool.
To Charge the Battery Pack:
Battery Pack (1)
Battery Socket (3)
Charger (2)
LED Light
connect here
Figure 1
Release
Button
1. Insert the Battery Pack (1) into the Bat-
tery Socket (3).
Plug the Charger (2) cord into the Bat-2.
tery Socket (3), then plug the Charger
intoanappropriateAC120V,60Hz
power outlet. The red LED light on the
Battery Socket will activate, indicating
the Battery Pack is charging.
The initial charge time is 3-5 hours, after 3.
which the Battery Pack should be re-
moved from the Battery Socket/Charger
assembly.
Note: When the Charger is plugged into a
power outlet and connected to the Bat-
tery Socket without a Battery Pack at-
tached,theLEDwillashfromgreen
to red, and then off. When the Battery
Pack is inserted into the Battery Socket
the LED changes to a solid red. The light
changes to green when the Battery Pack
is fully charged. Do not charge for over
5 hours. Do not place the Charger on
carpetingornearammables.
After each subsequent use, 3 hours of 4.
charging time is needed for the Battery
Pack to be fully charged. However, the
Battery Pack can be left to charge for 5
hours to ensure longer running time in
the tools.
If the Battery Pack will not hold a full 5.
charge, discharge batteries by keeping
the tool in the “ON” position until tool
slows or the light begins to dim. Do not
completely discharge batteries. Remove
Battery Pack from tool, allow it to cool,
and charge for 3-5 hours, making sure
not to exceed 5 hours of charging time.
When not charging, unplug Charger from 6.
outlet and store in secure location.
The batteries contained in the Battery 7.
Pack are nickel-cadmium (Ni-Cd). Do
not dispose of Ni-Cd batteries in house-
hold waste.
Follow all local regulations regarding the 8.
proper disposal of Ni-Cd batteries.
9. WARNING! If the Charger cord is
damaged, it must be replaced only by
a qualied service technician.