Harbor Freight Tools 93212 Lathe User Manual


  Open as PDF
of 37
 
Page 25For technical questions, please call 1-800-444-3353.SKU 93212
MAINTENANCE AND
SERVICING
Proceduresnotspecically
explained in this manual must
beperformedonlybyaqualied
technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the tool
to its “OFF” position and unplug
the tool from its electrical outlet
before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOUS INJURY
FROM TOOL FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
Cleaning, Maintenance, and
Lubrication
BEFORE EACH USE,1. inspect the
general condition of the tool. Check for
loose hardware, misalignment or binding
of moving parts, cracked or broken parts,
damaged electrical wiring, and any
other condition that may affect its safe
operation.
AFTER USE,2. wipe external surfaces of
the tool with clean cloth.
3. WARNING! If the supply cord of
this power tool is damaged, it must be
replacedonlybyaqualiedservice
technician.
Belt Inspection and Tensioning
Remove belt cover, if equipped.1.
Examine belt for cracks, tears in the 2.
backing, or other damage. Replace belt
if damaged according to steps below:
Loosen the motor mounting bolts and a.
slide the motor towards the other pulley
as far as possible.
Slide the old belt off of the smallest b.
pulley rst, then remove it.
Put the new belt around the larger c.
pulley rst, then around the smaller
pulley.
Move the motor away from the other d.
pulley until it is properly tensioned
according to the directions below.
Tighten the motor mounting bolts.
Check and adjust belt tension according 3.
to the steps below:
Deection
Distance
Press on the center of the longest a.
span on the belt with moderate nger
pressure. Then measure the deection
distance, the distance that the belt
moved. The belt should deect about
1/4”.
Ifthebeltdeectstoomuch,b. tighten
belt by loosening the motor mounting
bolts and moving the motor away from
the other pulley slightly. Secure motor
mounting bolts and retest tension. If the
belt is too long to be properly tensioned,
it must be replaced.
Ifthebeltdeectstoolittle,c. loosen
belt by loosening the motor mounting
REV 10b
 previous next