Filter
Top Products
Page 26 For technical questions, please call 1-800-444-3353. SKU 93212
bolts and moving the motor towards the
other pulley very slightly. Secure motor
mounting bolts and retest tension.
Before use, replace belt cover if 4.
equipped.
Gib Adjustments
Cross Slide
Crank (86A)
Compound Rest
Crank (86B)
Compound Rest A (108)
Gib (94)
Gib (107)
Cross
Slide
(100)
Figure 31
Adjusting the metal strips, or Gibs
(94/107) on the underside of the
Compound Rest A (108) and the Cross
Slide (100) helps to snug up those units
so they slide smoothly along the lathe.
The goal is to tighten them enough so
that the Compound Rest and Cross Slide
do not have any unnecessary movement,
but not so tight that they bind. It should
not be difcult to turn the hand Cranks
(86A/86B).
The Gibs become loose with use, so
the Compound Rest A and Cross Slide
should be checked periodically for any
play. Readjust the Gibs as needed.
Compound Rest A (108)
Gib Screws (106)
and Nuts (98)
Gib Screws (99)
and Nuts (98)
Gib (94)
Cross
Slide
(100)
Figure 32
To make the adjustment:
Unplug the Lathe.1.
Working one set of three gib Screws and 2.
Nuts at a time, loosen the three Nuts
(98) with a wrench (sold separately).
Holding the center Nut with the wrench, 3.
loosen or tighten the Center Screw (99
or 106) with a at head screw driver
(sold separately) and check the sliding
movement. It should be even and
smooth while removing any play. Adjust
as needed, then, holding the Screw with
the screw driver, tighten the Nut with the
wrench.
Repeat step 3 for the two side Screw/Nut 4.
sets.
Tailstock Alignment
The Tailstock (138) needs to be adjusted
for offset, then re-aligned before rst use
and any time the tool in the Tailstock is
changed.
To align the Tailstock:
Center drill both ends of a 6” long piece 1.
of round cold rolled stock. Set aside.
Turn a 60° point on a piece of scrap 2.
metal to make a dead center.
REV 10b