Filter
Top Products
NAILER
QUICK
CONNECTOR
QUICK
COUPLER
AIR
HOSE
QUICK
COUPLER
QUICK
CONNECTOR
OILER
REGULATOR
FILTER
AIR
COMPRESSOR
CONNECTION TO AIR SUPPLY
TESTING THE FULL SEQUENTIAL SAFETY TRIP MECHANISM
WARNING: Even though the Nailer should be empty during this
procedure, ALWAYS point the Nailer at a piece of scrap wood when testing.
1. Make sure the tool is disconnected from its air supply.
2. Completely empty the Magazine (85) of Nails. Then, close the Magazine.
(See Figure B.)
SKU 93257 For technical questions, please call 1-800-444-3353 PAGE 6
TRIGGER
(60)
MAGAZINE
(85)
SAFETY
(38)
FIGURE A
FIGURE B
AIR PLUG
(82-not included)
OPERATION
For best service, you should incorporate an oiler, regulator, and inline filter, as
shown in the diagram below. Hoses, couplers, oilers, regulators, and filters are all
available at Harbor Freight Tools. NOTE: If an automatic oiler is not used, for
smoother operation and to extend the life-span of the tool, put 3-5 drops of
pneumatic Tool Oil (93) in the attached Air Plug (82-not included) before each
use.
REV 12/06