Filter
Top Products
SKU 93257 For technical questions, please call 1-800-444-3353 PAGE 8
2. Check the Nail Support (88) inside the Magazine (85). The Nail Support can be
adjusted up and down to use various lengths of nails from 1-1/4” to 2-1/8”:
(See Figure D.)
A. 1-1/4” Long Nails (Turn Magazine Post (87) to
top
setting).
B. Between 1-1/4” and 2-1/8” Long Nails (Use
middle
setting).
C. 2-1/8” Long Nails (Use
bottom
setting).
FIGURE D
NAIL SUPPORT
(88)
NAILS
(NOT INCLUDED)
MAGAZINE POST
(87)
(TURN TO ADJUST HEIGHT)
3. Place a coil of Nails (not included) around the Nail Support (88) in the
Magazine (85). (See Figure D.)
4. Uncoil enough Nails to reach the Feed Pawl (42). Place the second Nail on the
coil between the teeth of the Feed Pawl, making sure the Nail head fits in the slot
in the upper portion of the Feed Pawl. (See Figure D.)
5. Swing the Magazine Cover (91) closed. Then, close the Door (32). Make sure
the Door closes securely. If it does not engage, the Nail head is not in the slot in
the upper portion of the Feed Pawl (42). (See Figure D.)
FEED PAWL
(42)
MAGAZINE COVER
(91)
DOOR
(32)
OPERATING THE NAILER
1. Attach the Nailer to the air supply at the Air Plug (82-not included). Start your
compressor and check the pressure, making sure it is set at the recommended 70
to 125 PSI. Do not exceed the maximum 125 PSI.
2. Rotate the Exhaust Cover (2) so that the exhaust air blast will be directed away
from the operator. (See Figure E, next page
Rev 11/06; REV 12/06