Filter
Top Products
SKU 95141 For technical questions, please call 1-800-444-3353 PAGE 4
15. Do not operate tool if under the influence of alcohol or drugs. Read warning
labels if taking prescription medicine to determine if your judgement or reflexes
are impaired while taking drugs. If there is any doubt, do not operate the tool.
16. Maintenance. The maintenance outlined in the “Maintenance” section of this
manual should be performed regularly. For your safety, this product should be
serviced or repaired regularly only by a qualified technician.
17. Compressed air only. Use clean, dry, regulated, compressed air at 90 PSI.
Never use oxygen, carbon dioxide, combustible gases, or any other bottled gas
as a power source for this tool.
18. Always grip the Impact Wrench firmly with both hands when operating the
tool.
19. Industrial applications must follow OSHA requirements.
20. Maintain labels and nameplates on the Impact Wrench. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a
replacement.
1. For best service, you should incorporate an oiler, regulator, and in-line filter, as
shown in the diagram below. Hoses, couplers, oilers, regulators, and filters are
all available at Harbor Freight Tools. NOTE: If an automatic oiler is not used,
put 3-5 drops of pneumatic Tool Oil (not included) in the tool’s quick connector
before each use. (See Figure A.)
REGULATOR
FIGURE A
FILTER
OILER
21. WARNING! The warnings, cautions, and instructions discussed in this
instruction manual cannot cover all possible conditions and situations that may
occur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by the
operator.
CONNECTING TO AN AIR SUPPLY
SAVE THESE INSTRUCTIONS