Filter
Top Products
SKU 95141 For technical questions, please call 1-800-444-3353 PAGE 6
6. Connect the air supply hose (not included) to the previously installed Quick
Connnector of the Impact Wrench. (See Figure C.)
7. Turn on the air compressor, and set its regulator at 90 PSI.
Do not exceed 90 PSI.
8. Wait until the air compressor’s regulator reaches 90 PSI. Then, insert the
previously installed socket onto the nut that is to be loosened or tightened.
9. Make sure to hold the Impact Wrench firmly with
both hands
, as torque from the
tool will cause the tool to twist. Then, squeeze the Trigger (27) to turn on the
tool. (See Figure C.)
10. While the work is in progress, you may need to change the directional rotation of
the tool. To avoid damaging the Impact Wrench, always make sure the tool
is at a complete stop before changing the rotational direction.
(See Figure C.)
11. When finished, release the Trigger (27) to stop the Impact Wrench.
(See Figure C.)
12. Turn off the air compressor. Squeeze the Trigger (27) of the Impact Wrench to
release any remaining air pressure in the system and tool. Disconnect the
tool from its air supply hose. Then, remove the socket from the tool and store
the socket in a safe location. (See Figure C.)
13. Make sure to store the Impact Wrench in a clean, dry, safe location out of reach
of children and other unauthorized people.
SOCKET
(NOT INCLUDED)
AIR SUPPLY HOSE
(NOT INCLUDED)
TRIGGER
(27)
FORWARD/REVERSE VALVE
(21)
FIGURE C