Filter
Top Products
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Always wear ANSI approved safety impact goggles when
performing any inspection, maintenance, or cleaning procedures.
2. WARNING! Prior to performing any inspection, maintenance, or cleaning of
the Impact Wrench, make sure to disconnect the air hose from the tool. Then,
squeeze the Trigger (27) again to release any compressed air in the system and
tool.
3. To clean the exterior of the Impact Wrench, wipe with a clean, damp cloth
using a mild detergent or mild solvent. Do not immerse the tool in liquids.
SKU 95141 For technical questions, please call 1-800-444-3353 PAGE 7
TROUBLESHOOTING
Problem Possible Solution
Impact Wrench does not turn on when
Trigger is squeezed.
1. Make sure to firmly squeeze the Trigger (27).
2. Make sure air compressor is on and its regulator
is set at 90 PSI.
3. Make sure all air system connections are secure
and that there are no leaks.
4. Make sure the air and oil filters in the air compressor
are not plugged.
5. Make sure the Air Filter (44) within the Air
Inlet (45) is not plugged.
Releasing the Trigger on the Impact
Wrench does not turn off the tool.
1. Turn off the air compressor. Release any remaining
compressed air from the system and tool. Disconnect
the air supply hose from the tool. Do not use the tool
until a qualified service technician repairs the tool.
4. When storing, always store the Riveter in a clean, dry, safe location out of reach
of children.
5. CAUTION! All maintenance, service, and repairs not mentioned in this
manual must only be performed by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR
WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN
FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES
ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.