Filter
Top Products
ASSEMBLY INSTRUCTIONS
1. Prior to use, the Impact Wrench requires the attachment of a 3/8”-18 NPT Quick
Connector (not included) to its Air Inlet (45). To do so, make sure the screen Air
Filter (44) is properly seated in the Air Inlet. Wrap approximately 3” of pipe thread
sealer tape (not included) around the male threads of the Quick Connector. Then,
firmly tighten the Quick Connector into the Air Inlet. (See Figure B.)
SKU 95141 For technical questions, please call 1-800-444-3353 PAGE 5
QUICK CONNECTOR
(NOT INCLUDED)
FIGURE B
OPERATING INSTRUCTIONS
3. Make sure the Impact Wrench is disconnected from its air supply hose prior to
installing or changing sockets (not included) on the tool.
4. Select the proper 3/4” impact socket for the job at hand. Then, firmly insert the
socket onto the Anvil (39) of the Impact Wrench. (See Figure C, next page.)
5. The Impact Wrench features a Forward/Reverse Valve (21) that allows you to
change the rotational direction of the tool. For a forward (clockwise) rotation,
move the Forward/Reverse Valve to the left. For a reverse (counterclockwise)
rotation, move the Forward/Reverse Valve to the right. (See Figure C.)
WARNING! Use eye and hearing protection. Always wear ANSI
approved safety impact goggles when using this Impact Wrench. Also,
wear ANSI approved hearing protection. Other people in the work area
must also wear appropriate ANSI approved safety equipment.
1.
2. Whenever possible, secure the workpiece in place, using a vise or clamps
(not included).