Filter
Top Products
SKU 95346 For technical questions, please call 1-800-444-3353 PAGE 4
Do not use the Auger Drill if the Kill Switch does not turn it off. Any tool that
cannot be controlled with its Kill Switch is dangerous and must be replaced.
Store idle tools out of reach of children and other untrained persons. Tools
are dangerous in the hands of untrained users.
Maintain tools with care. Properly maintained tools are less likely to malfunction
and are easier to control. Do not use a damaged tool. Tag damaged tools “Do
not use” until repaired.
Check for misalignment or binding of moving parts, breakage of parts, and any
other condition that may affect the tool’s operation. If damaged, have the tool
serviced before using. Many accidents are caused by poorly maintained tools.
Use only accessories that are recommended by the manufacturer for your
model. Accessories that may be suitable for one tool may become hazardous
when used on another tool.
SERVICE
Tool service must be performed only by qualied repair personnel. Service or
maintenance performed by unqualied personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts. Follow instruc-
tions in the “Inspection, Maintenance, And Cleaning” section of this manual.
Use of unauthorized parts or failure to follow maintenance instructions may create
a risk of electric shock or injury.
SPECIFIC SAFETY RULES AND PRECAUTIONS
IMPORTANT! Your Warranty is voided if:
You do not operate the Auger Drill with the proper 25:1 fuel mix in its fuel
tank. Never run the Engine with an improper fuel mix, low or no fuel mix. Run-
ning the Engine with an improper fuel mix, low or no fuel mix, will permanently
damage the unit.
You do not operate the Auger Drill with the proper amount of SAE 80-90
gear oil in its Gearbox. Never run the Auger Drill with low or no gear oil. Run-
ning the Auger Drill with low or no gear oil will permanently damage the unit.
Maintain labels and nameplates on the Auger Drill. These carry important infor-
mation. If unreadable or missing, contact Harbor Freight Tools for a replacement.
Always wear safety equipment. When operating the Auger Drill,
always wear ANSI-approved safety impact eye goggles, hearing
protection, heavy duty work gloves, sturdy steel-toed work boots,
and head protection.
2.
3.
4.
5.
6.
1.
2.
1.
a.
b.
2.
3.