Filter
Top Products
SKU 95346 For technical questions, please call 1-800-444-3353 PAGE 8
PRE-START INSTRUCTIONS
Fill the Fuel Tank
IMPORTANT! Your warranty is voided if you do not operate the Auger Drill
with the proper 25:1 fuel mix in its Fuel Tank (89). Never run the Engine with
an improper fuel mix, low or no fuel mix. Running the Engine with an improper fuel
mix, low or no fuel mix will permanently damage the unit.
To obtain the proper 25:1 fuel mix, combine 25 parts unleaded gasoline (89+ octane)
with 1 part 2-cycle oil in the provided Fuel Mix Container (36a). Cover and shake
to thoroughly mix before each fueling. NOTE: Mix only enough fuel for a few days
work. The maximum storage time of mixed fuel is three months.
GEARBOX (8a)
OIL FILL PLUG (20a)
FUEL TANK (89)
FUEL CAP (93)
FIGURE B
Once the proper fuel mix is obtained, remove the Fuel Cap (93). Fill the Fuel Tank
(89) approximately 3/4 full with the fuel mix. Then, replace the Fuel Cap.
(See Figure B.)
WARNING! NEVER attempt to ll the Fuel Tank (89) when the Engine is run-
ning or hot to the touch.
Fill the Gearbox
IMPORTANT! Your warranty is voided if you do not operate the Auger Drill
with the proper amount of SAE 80-90 gear oil in its Gearbox (8a). Never run
the Auger Drill with low or no gear oil. Running the unit with low or no gear oil will
permanently damage the unit.
Remove the Oil Fill Plug (20a) and carefully ll (approximately 8-1/2 ounces) the
Gearbox (8a). Then, replace the Oil Fill Plug and tighten securely.
(See Figure B.)
NOTE: Do not use dirty, used, or otherwise contaminated gear oil. Damage may
occur to the internal mechanisms of the Gearbox (8a).
1.
2.
3.
4.
1.
2.
3.