Filter
Top Products
E. Loosen the two Head Socket Head Screws (159) on the Idler Bracket (156).
Then loosen the Chain (52) by sliding the Idler Bracket. (See Figure P.)
F. Carefully rotate the Sprocket (201) by hand to change the Rollercase (136)
height. Make sure to leave the other Sprockets untouched. Do not rotate the
Sprocket more than one or two teeth. (See Figure P.)
G. Retighten the Chain (52) by securing the Idler Bracket (156) in position.
Then tighten the two Head Socket Head Screws (159) on the Idler Bracket
(156). (See Figure P.)
H. Set the Planer back on its Base (222). Then make a test cut to verify the
adjustment.
5. To clean or replace the Carbon Brushes: It may become necessary to clean
or replace the two Carbon Brushes (26A) when the Motor performance de-
creases, or stops working completely. The Carbon Brushes are located on
each side of the Motor Housing (28A). To do so:
A. Remove the two Brush Caps (25A). Then, remove the two Carbon Brushes
from the Brush Holders (27A).
B. If the Carbon Brushes are worn down more than 1/2, replace
both
Carbon
Brushes. If, however, the Carbon Brushes are just dirty they may be cleaned
by rubbing them with a pencil eraser.
C. When installing the Carbon Brushes, make sure the carbon portion of the
Carbon Brushes contact the Armature (20A) assembly and the springs face
away from the Motor. Also, make sure the springs operate freely.
D. After cleaning or replacement, replace the Brush Caps (25A).
E. New Carbon Brushes tend to arc or spark when first used until they
wear and conform to the Armature assembly. (See Assy. Diagram.)
6. To clean the exterior/interior of the Planer: Use compressed air. Do not
immerse any part of the unit in liquid.
7. CAUTION! All maintenance, service, or repairs not mentioned in this
manual must only be performed by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST
AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEI-
THER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR
WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACE-
MENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS,
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARIS-
ING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACE-
MENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
SKU 95518 For technical questions, please call 1-800-444-3353 PAGE 17