Filter
Top Products
SKU 98733 For technical questions, please call 1-800-444-3353. Page 3
Keep bystanders, children, and c.
visitors away while operating the
tool. Distractions are able to result in
the loss of control of the tool.
Personal safety
Stay alert. Watch what you are do-a.
ing and use common sense when
operating the tool. Do not use the
tool while tired or under the inu-
ence of drugs, alcohol, or medica-
tion. A moment of inattention while
operating the tool increases the risk
of injury to persons.
Dress properly. Do not wear loose b.
clothing or jewelry. Contain long
hair. Keep hair, clothing, and
gloves away from moving parts.
Loose clothes, jewelry, or long hair
increases the risk of injury to persons
as a result of being caught in moving
parts.
Avoid unintentional starting. Be c.
sure the switch is off before con-
necting to the air supply. Do not
carry the tool with your nger on the
switch or connect the tool to the air
supply with the switch on.
Remove adjusting keys and d.
wrenches before turning the tool
on. A wrench or a key that is left at-
tached to a rotating part of the tool
increases the risk of personal injury.
Do not overreach. Keep proper e.
footing and balance at all times.
Proper footing and balance enables
better control of the tool in unexpect-
ed situations.
Use safety equipment. f. A dust mask,
non-skid safety shoes and a hard
hat must be used for the applicable
conditions. Wear heavy-duty work
gloves during use. Wear a full face
shield if you are producing metal l-
ings or wood chips.
g. Always wear eye protec-
tion. Wear ANSI-ap-
proved safety goggles with
side shields during use.
h. Always wear hearing
protection when using
the tool. Prolonged expo-
sure to high intensity noise
is able to cause hearing loss.
Tool use and care
a. Avoid unintentional
misres. Be sure Trigger
(56) is in the OFF posi-
tion when not in use and
before plugging in. Do
not carry any tool with your nger on
the Trigger, whether it is attached to
an air source or not. Do not point tool
towards yourself or anyone whether it
contains nails or not.
Do not load nails with Trigger or b.
safety depressed. Unintentional r-
ing may occur. Always assume Nailer
contains fasteners.
Do not load fasteners when Nailer c.
is connected to air hose. Always
assume tool contains fasteners. Unin-
tentional ring may occur.
Properly adjust Nailer angle to d.
match corresponding fasteners
before inserting nail strip. Failure
to do so can cause Nailer to jam and
lead to personal and/or property dam-
age.