Filter
Top Products
SKU 98733 For technical questions, please call 1-800-444-3353. Page 4
Fire nails into an appropriate work e.
surface only. Do not attempt to re
nails into surfaces too hard to pen-
etrate. Do not drive nails on top of
other nails, or at too steep an angle.
Nails can ricochet, causing personal
injury. Never re this tool into the air
or point it toward yourself or another
person.
Hold tool away from head and f.
body during use. Tool may kick
back, causing injury.
Do not re fasteners too close to g.
edge of workpiece. They may split
the workpiece and y free, causing
personal injury.
Carry tool safely. h. Carry tool by
handle.
Use clamps or another practical i.
way to secure and support the
workpiece to a stable platform.
Holding the work by hand or against
the body is unstable and is able to
lead to loss of control.
Do not force the tool. j. Use correct
tool for application. The correct tool
will do the job better and safer at the
rate for which the tool is designed.
Disconnect the tool from the air k.
source before making any adjust-
ments, changing accessories, or
storing the tool. Such preventive
safety measures reduce the risk
of starting the tool unintentionally.
Turn off and detach the air supply
and safely discharge any residual
air pressure before leaving the work
area.
Store the tool when it is idle out of l.
reach of children and other un-
trained persons. A tool is dangerous
in the hands of untrained users.
Maintain the tool with care. m. Keep
tool clean. A properly maintained tool,
reduces the risk of binding and is
easier to control.
Check for misalignment or bind-n.
ing of moving parts, breakage of
parts, and any other condition that
affects the tool’s operation. If dam-
aged, have the tool serviced before
using. Many accidents are caused
by poorly maintained tools. There is a
risk of bursting if the tool is damaged.
Use only accessories that are o.
identied by the manufacturer for
the specic tool model. Use of an
accessory not intended for use with
the specic tool model, increases the
risk of injury to persons.
Service
Tool service must be performed a.
only by qualied repair personnel.
When servicing a tool, use only b.
identical replacement parts. Use
only authorized parts.
Use only the lubricants supplied c.
with the tool or specied by the
manufacturer.
Air source
a. Never connect to an air
source that is capable of
exceeding 120 PSI. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry,
regulated compressed air at the rated
Rev 09l