Filter
Top Products
SKU 99640 For technical questions, please call 1-800-444-3353. Page 7
SPECIFICATIONS
Air Pressure
Range
70-120 PSI
Maximum Air
Pressure
120 PSI
Air Inlet 1/4” -18 NPT
Fastener
Capacity and
Size Range
120 1/2” Crown Flooring Staples
Length: 1-1/2” to 2”
Gauge: 15 1/2 Ga
100 “L” or “T” Type Flooring Cleats
Length: 1-1/2” to 2”
Gauge: 16 Ga
Air
Consumption
4 SCFM @ 90 PSI
Safety Trigger
Slugging Actuation Only
(No Safety)
Accessories
Wrench Set
Slugging Hammer
Air Coupler Adapter
Air Tool Oil Dropper
Spare Base Plate
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown throughout the manual as soon as
possible.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
• This tool may be shipped with the
Arm (80) detached from the main
body. If so, follow these instruc-
tions:
1.
Arm (80)
Handle (69)
Bracket (72)
Nut (70) and
Washer (71)
Figure A
Set the Arm against the Handle (69)
and slide the Brackets (72) through
the Arm holes slots and holes.
Thread Washers (71) and Nuts (70)
over ends of Brackets.
See Figure A.
2. Wrench-tighten the Nuts until Brack-
ets are secured and the Arm is locked
against Handle.
Air Supply Setup
TO PREVENT
EXPLOSION:
Use only clean, dry, regulated,
compressed air to power tool.
Do not use oxygen, carbon
dioxide, combustible gases,
or any other bottled gas as a
power source for tool.
REV 08j; 09c; 09i