HP (Hewlett-Packard) 16500C Sander User Manual


 
LOAD :IASSembler
Command :MMEMory:LOAD:IASSembler <IA_name>[,<msus>],{1|2}
[,<module>]
This variation of the LOAD command allows inverse assembler files to be
loaded into a module that performs state analysis. The <IA_name>
parameter specifies the inverse assembler filename from the desired
<msus>. The parameter after the optional <msus> specifies which machine
to load the inverse assembler into. For example, a 1 specifies that the inverse
assembler files will be loaded into MACHINE 1 of the specified module.
The optional <module> parameter is used to specify which slot the state
analyzer is in. If this parameter is not specified, the state analyzer in the
currently selected module will be loaded with the inverse assembler file.
<IA_name> A string of up to 10 alphanumeric characters for LIF in the following form:
NNNNNNNNNN
or
A string of up to 64 alphanumeric characters for DOS in one of the following
forms:
NNNNNNNN.NNN when the file resides in the current directory or
\NAME_DIR\FILENAME when it does not reside in the current directory
<msus> Mass Storage Unit specifier. INTernal0 for the hard disk drive and
INTernal1 for the flexible disk drive.
<module> An integer, 1 through 5 for the HP 16500C alone. 1 through 10 with an HP
16501A connected. Although the parser will accept the values –1 and –2,
they will generate a disk error.
Example OUTPUT XXX;":MMEMORY:LOAD:IASSEMBLER ’I68020 IP’,1"
OUTPUT XXX;":MMEM:LOAD:IASS ’I68020 IP’,INTERNAL0,1,2"
MMEMory Subsystem
LOAD :IASSembler
12–16