Hitachi C10FL Saw User Manual


 
16
6. The, re-loosen the bevel lock handle and reset the
blade at the maximum bevel position (45°), then
tighten the bevel lock handle.
7. Check again to see if the blade is 45° to the table. If
not, repeat step 5.
Fig. K
3
4
BLADE TILTING INDICATOR (Fig. L)
1. When the blade is positioned at 90°, adjust the blade
tilt pointer to read 0° on the scale.
2. Remove the magnifier, position the pointer over 0°
and replace the magnifier.
NOTE: Make a trial cut on scrap wood before making
critical cuts. Measure for accuracy.
Fig. L
0°
5°
10°
BLADE PARALLEL TO THE MITER GAUGE GROOVE (Fig. M)
To avoid injury from an accidental start, make sure the
switch is in the OFF position and the plug is disconnected
from the power source outlet.
This adjustment was made at the factory, but it should be
rechecked and adjusted if necessary.
This adjustment must be correct or kickback could result
in a serious injury and accurate cuts cannot be made.
1. Remove the yellow switch key and unplug the saw.
2. Raise the blade guard away from the blade.
3. Raise the blade to the maximum height and set the
belel angle at 0°.
4. Select and mark with a felt tip marker, one blade tooth
with a right set angle and position this tooth at the
front of the saw approximately 1/2 above the table.
5. Place the combination square base (1) into the right
side miter gauge groove (2) flush against the inside of
the miter gauge groove. (Fig. M)
6. Adjust the ruler so it touches the front marked tooth
and lock ruler so it holds its position in the square
assembly.
7. Rotate the blade to the rear of the saw bringing the
marked tooth approximately 1/2above the blade.
8. Carefully slide the combination square to the rear until
the ruler touches the marked tooth.
9. If the ruler touches the marked tooth at the front and
rear position, no adjustment is needed at this time. If
not, perform adjustment procedure described in next
section.
Fig. M
1
2