Filter
Top Products
— — 11
SAW MOUNTED TO WORK SURFACE (Fig. B)
1. If the leg set will not be used, the saw must be
properly secured to a sturdy workbench using the four
mounting holes at the base of the saw.
2. The surface of the table where the saw is to be
mounted must have a hole large enough to facilitate
sawdust fall-through and removal.
3. Square the saw on the mounting surface and mark the
location of the four 3/8" mounting holes (1).
4. Drill 3/8" hole into the mounting surface.
5. Mark an 11" square (2) centered between the four
mounting holes (1).
6. Cut out and remove the square.
7. This opening will allow sawdust to fall through the
saw base.
8. Place the saw on the work surface, and align the
mounting holes of the saw with those drilled through
the surface.
9. Fasten the saw to the work surface.
WARNING
Do not operate this machine on the floor. This is very
dangerous and may cause serious injury.
Fig. B
1
2
S QU ARE
CU TOU T
WARNING
Failure to provide the sawdust fall-through hole will cause
sawdust to build up in the motor area, which may result in
fire or cause motor damage.
KEEPING THE AREA CLEAN
1. Sawdust and wood chips that fall from under the saw
will accumulate on the floor.
2. Make it a practice to pick up and discard this dust
when you have completed cutting.
ADJUSTING THE CUTTING LINE INDICATOR (Fig. C)
1. Take off the cover (1)by loosening screws (2).
2. Adjust the pointer (3) to align to the blade.
3. Mount the cover on the table to fix the pointer.
NOTE: The pointer was set up to align to the right side of
the blade when packing.
Fig. C
1
2
3
INSTALLING BATTERY FOR LED LIGHTING(Fig. B)
1. Open the cover (1) of battery box on the top of blade
guard.
2. Install 2 pieces of 1.5V 3A batteries into the battery
box in right direction.
3. Close the cover.
4. Turn on the switch (2) to check the LED lighting.
Fig. D
2
1
BLADE RAISING HANDWHEEL (Fig. E, F)
1. Attach the handwheel (1) to the elevation screw (2) at
the front of the saw.
Make sure the slots (3) in the hub of the handwheel
engage with the pins (4). (Fig. E)
2. Attach and tighten the dome nut (5) at the end of the
shaft (Fig. F).
Fig. E
3
1
24
BLADE TILTING HANDWHEEL (Fig. G, F)
1. Attach the other handwheel (6) to the blade tilting
screw on the side of the saw in the same manner as
above.
2. Attach and tighten the handwheel dome nut (5).
Fig. F
5
6