Filter
Top Products
— 3 —
WARNING
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains chemicals
known to the state of California to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemicals, work in a well-ventilated area and work with approved safety equipment such as dust masks that are
specially designed to filter out microscopic particles.
PRODUCT SPECIFICATIONS
SAW
Table Size ....................................... 26-1/16” x 19-21/64”
Table Extensions ........................... 2- Right, Rear
Extension Fence Capacity ............. 24” Right
Blade Size....................................... 10”
Rip Scale ........................................ YES
Rip Fence........................................ YES
Miter Gauge ................................... YES
Maximum Cut Depth @ 90°.......... 3-1/8”
Maximum Cut Depth @ 45°.......... 2-1/2”
Net Weight ..................................... 64.5 LBS
WARNING
To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.
This table saw is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt / 15 Ampere time
delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or damaged in any
way.
Before using your table saw, it is critical that you read and understand these safety rules. Failure to follow these rules
could result in serious injury to you or damage to the table saw.
MOTOR
HP (Maximum developed) ............ 3.0
Type ................................................ Universal
Amps .............................................. 15
Voltage ........................................... 120
Hz .................................................... 60
RPM (no load) ................................ 5000
Overload Protection ...................... YES