Filter
Top Products
15
PRE OPERATION CHECKLIST
Before leaving our factory, every machine is thoroughly tested. Follow our instructions strictly and
your machine will give you long service in normal operating conditions.
Before starting up the machine, make sure you read this entire Operation’s Manual and are fa-
miliar with the operation of the machine.
WITH MACHINE COLD AND SETTING LEVEL:
1. Gasoline Models: Check engine oil. Fill to the full mark on dip stick with 10W30 oil, class MS, SD, SE or better.
2. Electric Models: Verify all electrical connections are intact.
1 - 2 HOUR OPERATION CHECK LIST:
ALWAYS place the machine on a level surface with the engine/motor “OFF", the ignition switch set in
the “OFF” position and disconnected from the power source before performing any maintenance. Let
the machine cool down!!
1. Check the engine air cleaner hose clamps. Tighten as required.
2. Tension the blade drive V-belts. DO NOT over tension!!
SCHEDULED MAINTENANCE QUICK REFERENCE:
Before performing any maintenance, ALWAYS place the machine on a level surface with the
engine/motor “OFF” and the ignition switch set in the “OFF” position.
SERVICE DAILY:
1. Check engine oil level.
2. Check blade guard for damage.
3. Check hoses and clamps for damage
or looseness. Tighten or replace as necessary.
4. Check air cleaner. Clean or replace as required.
5. Clean the reservoir pan frequently.
6. At the end of each day, ush clean water through the
water pump and hoses
SERVICE EVERY 50 HOURS:
1. Replace engine oil and lter.
2. Clean engine air ns.
3. Check blade drive V-belt tension.
DO NOT over tension!!!
4. Clean engine fuel bowl.