Filter
Top Products
1.
Disconnect machine from the power
source.
2.
Raise saw arm to its highest position and
close cutting pressure control valve to hold
saw arm in place.
3.
Locate tracking adjustment plate on the back
side of the driven blade wheel.
4.
Loosen the three bolts (A - Fig. 8) locatedon
the top of the tracking nuts.
5.
Tracking adjustment is accomplished by either
loosening or tightening three adjusting nuts
(B - Fig. 8).
6.
Tracking is set properly when the back of the
blade lightly touches the wheel flange. Note:
over-tracking (allowing blade backto rub hard
against wheel flange) will damage the blade
wheels and blade.
7.
Tighten locking bolts (A) once properly
tracking is completed.
8.
Connect machine to the power source.
Automatic Shut-Off Adjustment
The motor should shut off immediatelyafter the
blade has cut through the materialand just before
the head comes to rest on the horizontalstop bolt.
If the machine continuesto run after thework piece
has been fully cut, locateand adjust the micro
switch mounting plate down. If the machineshuts
off before the work piece has been completelycut,
move the micro switch mounting plate up.
Thrust Roller Adjustment
1.
Disconnect machine from the power
source.
2.
Loosen two hex socket cap screws (A - Fig.
9). Note: Left guide roller has two hex socket
cap screw; right guide roller has one (HBS-
916Wonly) The HBS-1018Whas two
screws on each guide..
3.
Move guide seat (B) up or down untila
clearance of .003" to .005" between backof
blade and thrust roller is obtained.
Fig. 9
8