Filter
Top Products
Electrical Connections
it WARNING
All electrical connections must be done by a
qualified electrician! Failure to comply may
result in serious injury!
it WARNING
Disconnect machine from the power source
before changing any voltage components!
Failure to comply may cause serious injury!
The HBS-916W bandsaw is ratedat 115/230V,1Ph.
and is prewired 115 volt from the factory. The
HBS1018Wis rated at 230V, 1Ph.only. Confirm
power available at the saw's location is the same as
the saw is wired. To switch the HBS-916Wfrom
115V to 230V, the following itemswill haveto be
changed:
.
Main Motor - follow diagram insidejunction box
cover.
.
Coolant Pump - Removechip pan on front of
saw, remove junction box cover on pump, and
follow diagram insidejunction box cover.
.
Control Transformer - Open electrical panel
on rear of base and switch primarywire on
transformer from 115Vto 230V.
Machine must always be correctly grounded.
Note: The power cord end will have to be changed
to one that is rated 230V when changing to the
higher voltage.
Controls - Figure 5
A.
Power Indicator Light (A) - lit whenever
machine is running.
B.
Start Button (B) - depress to start bandsaw.
C.
Emergency Stop Button (C) - depress to
immediately stop all machine functions.
o.
Coolant Switch (0) - Turn arrowto "I" to turn
on flow of coolant. Turn arrow to "0" to stop
flow of coolant.
Fig. 5
3