Filter
Top Products
4.
Tighten two hex socket cap screws (A).
5.
Repeat for other blade guideassembly.
6.
Connect machineto power source.
Guide Roller Adjustment
1.
Disconnect machine from the power
source.
2.
Loosen blade guides (A - Fig. 10)by loosening
screws (B). Slide blade guides away from
blade.
guideseat
B
3.
Loosen locking screws (C) by usinga hex
wrench.
4.
Adjust the eccentric bushingswith a
combination wrench until the ball bearingsare
snug to the blade. Note: bladeshouldtravel
freely up and down betweenthe ball bearings.
Do not pinch the blade.
A
5.
Fig. 10
Tighten locking screws (C).
6.
Slide blade guides back into contact with blade
and tighten screws (B).
7.
Connect machineto the power source.
Bow Weight Adjustment
Bowweight is one of the most important
adjustments of the saw. If the bow weight is not set
properly, one can expect poor performance,
crooked cuts, tooth stripping, stalling, andthe blade
popping off the bladewheels. The hydraulicfeed
rate unit will not compensate for improper bow
weight. Bow weight has been set at the factory and
should not need any adjustment. If adjustment is
necessary:
1.
Disconnect the machine from the power
source.
2.
Turn hydraulic valve to on (F - Fig. 5)
3.
Turn cutting pressure control valve (E - Fig. 5)
counter-clockwise until it stops.
9