Filter
Top Products
3.
Remove shaft (A- Fig. 2) from the motor mount
bracket.
4.
Carefully lift motor and line up holes in the
motor mounting plateand the motor bracket.
5.
Slide motor support shaft into motor mount
bracket to hold the motor in place.
6.
Fasten shaft with nut and washer.
7.
Loosen strain relief nut on the motorjunction
box. Removethe junction box cover. Insert
wire through strain relief andwire to the
terminal strip using the diagram on thejunction
box cover. Tighten the strain relief nut and
replace the junction box cover.
Remove two hex cap bolts and washers
8. (A, Fig. 3) from the right side of the saw arm.
9.
Slide belt cover (8, Fig. 3) around pulley shafts
and attach to saw with two hex cap bolts and
two washers.
10. Lift motor and place v-belt around both pulleys.
Lower motor.
11. Tension the v-belt by pushing down on the
motor and tightening the lock handleon the
motor tilt plate. Correct tension is achieved
when finger pressure between the two pulleys
causes approximately a 1/2"deflection. See
Figure 4.
12. Close pulley cover door and fasten with lock
knob.
13. Fasten work stop rod (#17 - page 12) to saw
bed (#11) by inserting into bed and turning
clockwise until tight. Place work stop bracket
(#16) onto stop rod (#17) and tighten lock
handle (#20). Attach stop screw (#19)to stop
bracket (#16) with lock handle (#18) and
tighten.
Fig. 2
Fig. 3
Fig. 4
2